products contacts

 



 

     This is a fully built glider that needs only radio installation. Minimum weight of the fuselage and V-tail, the long tail moment and large tail surfaces enhance low speed handling.

Models variants, which were developed, manufactured, and tested in flight.
modifications 
Item Nr.   name wings (S4083mod foil) fuselage
1501

  Simply the best 1.5

  standard model

A,

A (el),

B,

B (el)

1502     Simply the best 1.5/5   standard model
1503

  Simply the best 1.5   with ailerons
1504

  Simply the best 1.5/5   with ailerons
1505     Simply the best 1.5   with ailerons and flaps
1506  

  Simply the best 1.5/5

  with ailerons and flaps
1507

  Simply the best 1.5

  with pipe carbon longeron
1508

  Simply the best 1.5/5   with pipe carbon longeron
1801

  Simply the best 1.8

  standard model

1802

  Simply the best 1.8/5   standard model
1803

  Simply the best 1.8   with ailerons
1804

  Simply the best 1.8/5   with ailerons
1805     Simply the best 1.8   with ailerons and flaps
1806  

  Simply the best 1.8/5

  with ailerons and flaps
 
The wing is a built-up Kevlar sheeted D-box design that utilizes carbon fiber faced balsa ribs and a carbon fiber strip trailing edge. The spars are made of HiTech carbon plates with balsa vertical direction and whipped with kevlar thread. The carbon longerons of special quality provide super strength.The carbon landing edge has minimum weight and maximum srength. All plastic elements of the wing are made with high pressure and temperature of 150C.  The rear section of the wing is covered with Oracover Lite. The wing has three sections connected with joiners. The wings are made extremely accurate, the construction is very strong, rigid and light and the construction will be not damaged by the environmental influence. The construction of the model allows to fly the model for a long time and it will be still as a new one.
 

The hand-built V-tail is made from contest balsa and laminated with carbon fiber strips, then covered with Oracover Light. The elevators are covered and hinged.The stabiliser has an original joiner and can be easily removed or attached to the fuselage. It is cool for transporation. The model is completed with original carbon horns.

 

Weight

Fuselage A, A (el)

52 g

Fuselage B, B (el)

70 g

Tail

16 g

Wings

Simply the best 1.5

115 g

Simply the best 1.5/5

120 g

Simply the best 1.8 130 g
Simply the best 1.8/5 135 g
 

 

 

 
 The fuselage is all Kevlar with carbon fiber reinforcement and gel-coated different colors. The canopy is hand fitted and has a unique built in latch system that is both very light and very easy to use. The place for the finger hole necessary for the cool launch is prepared on the fuselage (it is reinforced with carbon). 
 

 
 

 If you have any questions about this glider, please contact the designer: khodosov_f3k@mail.ru .